Holybro PM02 V3 Power Module (12S)

Holybro PM02 V3 Power Module (12S) is a Holybro catalog item in Power Modules & Distribution. Review the model details below and request compatibility and supply information for civilian use.

Model specifications

Manufacturer technical notes

Description:This PM02 Power Module provides a simple way to supply regulated 5.2V to flight controller from the battery while providing current consumption and battery voltage measurements via analog signal through a 6 Pin JST-GH cable. It comes with pre-soldered wires, capacitor, and XT60 connector on both ends, along with shrink tubing on the PCBA for physical protection. Specification:

Input Voltage: 2S-12S

PCB Cont. Current Rating: 60A

PCB Burst Current Rating: 100A (<60 Sec)

Max Current Sensing: 120A

Output: DC 5.2V & 3A Max

Voltage Divider: 18.182

Amperes per Volt: 36.364

Please Note: - The XT60 Plug and 12AWG wire that are pre-soldered on the board is rating for 30A continuous current and 60A burst current (< 60 Seconds). If a higher current is being used, the plug type and wire size should be changed accordingly. You can refer to this chart for reference. - This PM02 Power Module uses analog data output and is not compatible to the Pixhawk 5X & 6X (Requires a digital PM like PM02D).

- 1x Power Module with XT60 Connectors Board (pre-soldered)- 1x Electrolytic capacito: 220uF 63V (pre-soldered)- 1x Molex 6 Position Connector 15 cm- 1x JST GH 6 Position Connector 15 cm

Product inquiry

Availability, price, package contents and hardware revision are confirmed on inquiry. This listing does not assert local stock, a delivery date or official distributor status. Confirm voltage, connectors, firmware and operating requirements before use.

• Original manufacturer model information
• Manufacturer documentation
• Manufacturer documentation